Repository navigation
Conversation
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_013VUubhHeYSMGSSDXZkKZss
Adds Detect/PokemonBDSP_AutoStory_TrainerCardReader from rebuild/src 1da5f30 (lab #449). Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_013VUubhHeYSMGSSDXZkKZss
…ation#1910) * Sockets: add a per-connection id to server socket sends send() can now be given the connection_id() the caller captured when it started writing. The id increments on every accept, under the socket's lock, and send() compares it against the current id at transport selection and on every loop iteration (queue time and run time in the Qt backend). A write that outlived its connection - the peer disconnected and a new client was accepted in the meantime - is refused instead of being delivered into the new client's socket. Motivated by the in-app HTTP server: its per-connection task may be inside a long handler call when the client disconnects, and a fast reconnect can be accepted before the task notices; without the id, its final response could be written into the new client's stream. Default argument (0 = no check) keeps existing callers unchanged. Test: Sockets - A send for a replaced connection is refused (runs on the Qt, POSIX, and WinSocket backends). * Sockets: report connection_id() as 0 when no connection is active The documented contract ("0 when no connection is active") now holds in all three backends: the accessor reports 0 whenever the socket is not CONNECTED. The stored counter stays monotonic - resetting it on close would let a queued write from the previous connection match the id of the next one - and send() compares against the counter, so the stale-send refusal is unaffected. Test_Sockets_StaleSend now also checks the idle state before and after the first connection. * Sockets: move the connection_id() monotonicity note to the base class Suggested by review: the note explaining why the counter is never reset was duplicated in all three backends; it now lives once in the abstract class next to the connection_id() contract. Comment-only change. --------- Co-authored-by: PA Dev Bot <344001113+pa-devbot@users.noreply.github.com>
…w fixes Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_013VUubhHeYSMGSSDXZkKZss
…w fixes Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_013VUubhHeYSMGSSDXZkKZss
…eckpoint retry loop (#391)
* FRLG SpriteReader fixes and tests * allow for mirroring sprites left to right in SpriteDatabase
…d leg trace and replay (#464) Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_013VUubhHeYSMGSSDXZkKZss
…de moves to #467-#470 Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_013VUubhHeYSMGSSDXZkKZss
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_013VUubhHeYSMGSSDXZkKZss
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_013VUubhHeYSMGSSDXZkKZss
…1879) * HttpServer: add a minimal Qt-free HTTP/1.1 server on AbstractServerSocket A minimal HTTP/1.1 server for a single local client that issues one request at a time (e.g. an MCP client), built on the socket library instead of Qt: - One connection at a time (the server socket's model); requests are processed in order, so pipelined bytes simply wait in the buffer. - The per-connection task does all parsing and writing; the socket's receive callbacks only append data and flip flags. The user handler may block on another thread (e.g. the program thread) and can poll HandlerContext::connection_alive() to bail out of long-running work; responses are discarded if the connection dies meanwhile. - Content-Length bodies only (chunked -> 411), sizes capped (8 KB request line, 64 KB headers, 1 MiB body, 2 MiB buffer), "Expect: 100-continue" answered, strict request/header validation (400), responses always carry Content-Length. - start()/stop() are fully synchronous from the caller's point of view once on_listen_finished has fired: stop() closes the connection, waits for the in-flight handler, and joins the socket's worker threads, so the server can be started again afterwards. No TLS, no upgrades, no method routing or auth: the user handler owns all of that. 10 loopback tests (raw ClientSocket clients) cover the happy path, keep-alive, pipelining, Connection: close, 400/411/413, 100-continue, disconnect and stop() during a handler, and second-client rejection. Part of the groundwork for the in-app MCP server; stacks on the ServerSocket factory alias PR. * HttpServer: fix CI build failures - Rename ParseState::ERROR to ParseState::ERROR_RESPONSE: ERROR is a macro on Windows (winerror.h), which broke the qualified name on MSVC and clang-cl (C2589). - Keep the AsyncTask handle from ThreadPool::dispatch in the stop-during-handler test: dispatch is [[nodiscard]] and clang's -Wunused-result (CI's -Werror) rejects discarding it. Its destructor also waits for the trivial release task to finish. * HttpServer: inherit from AbstractHttpServer; address review Split the request/response types, the handler contract, and the listener events out into AbstractHttpServer (stacked on the extract-abstract-http-server PR); HttpServer now implements that interface, with the types re-exported under its own name. Fixes from the review: - Deadlock in on_connect(): the connection task handle was moved into m_connection_task while holding m_lock, and destroying the old handle blocked on the old task, whose final cleanup takes m_lock. Task handles now live in m_tasks under a dedicated m_task_lock (the socket library's m_task_lock pattern): on_connect() dispatches outside m_lock and never waits on an old task, so a new client is no longer held up while the previous handler is still running. - Deadlock in stop(): the socket was destroyed while holding m_lock, and ~ServerSocket joins the socket's worker threads, whose callbacks take m_lock. The socket is now moved out under m_lock and destroyed after releasing it. - Busy-spin on partial requests: the wait predicate was !buffer.empty(), which is permanently true once a partial request is buffered. It now requires the buffer to have grown past what the parse just saw, plus the dead/stop flags. - Chunked requests: 501 Not Implemented instead of 411 (RFC 9112). - The 413 check at parse time was unreachable (an incomplete request is always smaller than the buffer cap); the 2 MiB buffer cap is now enforced when data is appended instead, closing the connection. - end_connection() only closes the socket's connection while it still belongs to this connection, so a task noticing its own connection died late cannot close the next client's connection. - Documented that start()/stop() are not thread-safe with each other. Test: new case that a connection flooding past the buffer cap is closed without a response while the server keeps listening; chunked case now expects 501. * HttpServer: close the reconnect write race from the review The socket's connection thread sets the state back to LISTENING before it reports the disconnect, so a fast reconnect can be accepted before the old connection's on_disconnect callback runs. Two consequences: - The old connection's task could then write its final response through socket->send() into the new client's socket (send() has no per-connection identity; it writes whatever the socket is connected to). on_connect() now marks the connection it replaces dead (and notifies it) before the new one takes over, so the old task's post-handler check discards its response. - on_disconnect() marked m_connection dead, which in that window is the new client's connection: it would kill the new connection task. It now only does so while the socket is not already CONNECTED to the next client. Test: a client disconnects while its handler is still blocked on a gate; a second client connects (replacing the first in the server) before the gate is released. The first handler's late response must be discarded, and the second client's stream must contain only its own response. * HttpServer: address the second review round Five items from the fresh review: - [P1] stop() could hang waiting for a handler: the socket suppresses its disconnect callback for a close_connection() close, so a handler polling connection_alive() kept seeing true while shutdown waited for it. stop() now marks the active connection dead before it waits. The stop-during-handler test now polls connection_alive() after the gate, which would spin forever without the mark. - [P1] A response could reach a different client after reconnection: every write now carries the connection's socket id (AbstractServerSocket::connection_id(), new), so the socket refuses a write whose connection was replaced. This closes the last of the 'task outlives the connection' windows; the id check and the transport selection happen under the socket's lock. - [P2] Expect: 100-continue stalled clients: the interim response was sent only after the complete request (including body) was parsed, which a client waiting for it before sending the body never sees. Parsing now reports a separate NEED_BODY state (headers complete and valid, body pending), and the 100 is answered at that point. The test now performs the real two-phase handshake. - [P2] Complete headers bypassed the 64 KiB limit: the in-progress check only fires while the terminator is still missing. The completed header boundary is now checked against the limit too, with a test sending a ~75 KiB header section in one piece. - [P2] The test client's receive buffer was a data race: 'received' and the error strings are now protected by the waiter's mutex, and assertions use synchronized snapshots (same for the server listener's listen error). * Cleanup --------- Co-authored-by: PA Dev Bot <344001113+pa-devbot@users.noreply.github.com> Co-authored-by: Alexander Yee <a-yee@u.northwestern.edu>
The SystemKeyboardDetector screenshots are on the fork's CommandLineTests main, not upstream's, so the image tests could not load them. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_013VUubhHeYSMGSSDXZkKZss
# Conflicts: # SerialPrograms/Source/ComputerPrograms/ComputerPrograms_UnitTestRunner.cpp
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_013VUubhHeYSMGSSDXZkKZss
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_013VUubhHeYSMGSSDXZkKZss
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Add this suggestion to a batch that can be applied as a single commit.This suggestion is invalid because no changes were made to the code.Suggestions cannot be applied while the pull request is closed.Suggestions cannot be applied while viewing a subset of changes.Only one suggestion per line can be applied in a batch.Add this suggestion to a batch that can be applied as a single commit.Applying suggestions on deleted lines is not supported.You must change the existing code in this line in order to create a valid suggestion.Outdated suggestions cannot be applied.This suggestion has been applied or marked resolved.Suggestions cannot be applied from pending reviews.Suggestions cannot be applied on multi-line comments.Suggestions cannot be applied while the pull request is queued to merge.Suggestion cannot be applied right now. Please check back later.
Depends on #332 (autostory/engine), through base
bdsp/rebuild-base: #332 plus the lab core and tooling at rebuild/src, which has no PR of its own, and #464 (the shared leg trace and replay) merged in. The diff shows only this PR.The BDSP AutoStory rebuild starts here, with one squashed PR per layer cut from rebuild/src. This one holds the detectors only: the menu, name-list and transition watchers in PokemonBDSP/Inference, plus the AutoStory battle menu reader, intro menu, menu cursor, overworld detectors and the Trainer Card reader that 01.04's badge check uses (from lab #449). It replaces the detector parts of #152 and #148.
Built SerialProgramsTests locally (ccache, -j4). The PokemonBDSP, shared Story and LabChannel suites ran 256 passed and 28 failed, all 28 being the detector image tests that need the CommandLineTests checkout. Code health: 0 failures.
🤖 Generated with Claude Code
https://claude.ai/code/session_013VUubhHeYSMGSSDXZkKZss