Homemade Arduino Nano based driver for the Neewer BP300 LED panel.
- Single controller to sync two LED panels
- Color balance between cool and warm
- Brightness balance between two LED panels
- Total brightness adjustment
- Basically PWM followed by a logic-level MOSFET, e.g. IRLZ44N
- Utilizing timers 1 and 2 of the ATmega328 chip to generate 2x2 PWM signals up to ~60kHz common frequency and individual duty cycles
- LEICKE ULL 5V 8A or 6A
- Connector 5.5x2.5mm (+)
- Actually 5.5V not 5.0V output voltage
- Audible noise below 7W load
- Meanwell GST60A05-P1J 5V 6A or medical as possible alternative
- Arduino Nano compatible clone
- Fittingly VIN between 5V and 12V
- Otherwise Pololu S7V8F5
- Extension cable LiYY 3x0.34mm²
- Cable connector M13 5A
| Label | Native wire | Extension wire | Connector pin |
|---|---|---|---|
| W- | Yellow | Green | 1 |
| C- | Black | White | 2 |
| + (5V) | Red | Brown | 3 |
| Color | Resistor |
|---|---|
| G | 470 |
| R | 2k |
| B | 10k |
- 3x10k
- 2x3A slow or fast
- TEKO 362 or similar
